Package org.orekit.estimation.measurements.gnss

This package provides methods to handle GNSS measurements.

See: Description

Interface Summary

Interface	Description
AmbiguityAcceptance	Interface defining ambiguity acceptance tests.
CycleSlipDetectors	Interface for phase measurement cycle-slip detection.
IntegerLeastSquareSolver	Interface for algorithms solving integer least square problems.
MeasurementCombination	Interface for combination of measurements.

Class Summary

Class	Description
AbstractCycleSlipDetector	Base class for cycle-slip detectors.
AbstractDualFrequencyCombination	Base class for dual frequency combination of measurements.
AbstractLambdaMethod	Base class for decorrelation/reduction engine for LAMBDA type methods.
AbstractSingleFrequencyCombination	Base class for single frequency combination of measurements.
AmbiguitySolver	Class for solving integer ambiguity problems.
CycleSlipDetectorResults	This class is used to contains all the data computed within cycle-slip detector.
GeometryFreeCombination	Geometry-free combination.
GeometryFreeCycleSlipDetector	Geometry free cycle slip detectors.
GRAPHICCombination	GRoup And Phase Ionospheric Calibration (GRAPHIC) combination.
IntegerBootstrapping	Bootstrapping engine for ILS problem solving.
IntegerLeastSquareSolution	Class holding a solution to an Integer Least Square problem.
IonosphereFreeCombination	Ionosphere-free combination.
LambdaMethod	Decorrelation/reduction engine for LAMBDA method.
MeasurementCombinationFactory	Factory for predefined combination of measurements.
MelbourneWubbenaCombination	Melbourne-Wübbena combination.
ModifiedLambdaMethod	Decorrelation/reduction engine for Modified LAMBDA method.
NarrowLaneCombination	Narrow-Lane combination.
Phase	Class modeling a phase measurement from a ground station.
PhaseBuilder	Builder for Phase measurements.
PhaseMinusCodeCombination	Phase minus Code combination.
PhaseMinusCodeCycleSlipDetector	Phase minus code cycle slip detectors.
SimpleRatioAmbiguityAcceptance	Ambiguity acceptance test based on a ratio of the two best candidates.
WideLaneCombination	Wide-Lane combination.
WindUp	Modifier for wind-up effect in GNSS phase measurements.
WindUpFactory	Factory for wind-up modifiers.

Enum Summary

Enum	Description
CombinationType	Enumerate for combination of measurements types.

Package org.orekit.estimation.measurements.gnss Description

This package provides methods to handle GNSS measurements.

The two main types of GNSS measurements are code and carrier phase measurements. This package provides several methods to handle these two types of measurements (e.g. combination of measurement, phase ambiguity resolution, modeling of wind-up effect, etc.).